Water Shut Off Valve Leaking At Stem

Several considerations dictate which is the best water shut off valve for your needs including the size of the inlet diameter and outlet diameter as well as how the valve is operated.

Water shut off valve leaking at stem.

On a new water valve this almost always stops the leak. A water shut off valve leaking can make a mess and waste water. Locate and shut off water supply to the line that feeds the leaking valve. Water shut off valves can also leak at various points on the valve.

For instance a standard stop and waste valve has three other washers that can leak in addition to the washer that shuts the water off. So if there is a leak at the valve stem it most likely means the valve is not shut off all the way. The first thing you should do to stop the leak is to tighten the packing nut. Unscrew the handle the packing nut and the threaded valve stem photo 2.

Turn off the water at the house s main shutoff then disassemble the problematic shutoff valve without disconnecting the valve from either the water supply line or the line leading to the toilet. First shut off the water to the leaking water valve. Replacing old graphite valve stem packing with new teflon seal. 1 x research source open a faucet to relieve back pressure on water line.

If it doesn t the packing washer is probably damaged and will need replacement. Step by step instruction showing how to stop a shut off valve from leaking at the stem. Water shut off valves often leak at the handle or the stem after they. Next remove the handle from the stem and then loosen and remove the packing nut.

Place a bucket or a thick towel on the floor under the leaky valve just in case some residual water leaks out during work. This valve usually is in the basement or a utility closet and it will be clearly labeled. You may need to shut off water to the entire house if there is no cut off for the line. To tighten the packing nut follow these directions.

Multi turn shut off valves have a handle that when tightened forces a rubber gasket onto a seat in the middle of the valve that restricts water. The packing nut is responsible for making a watertight seal where the valve stem meets the water line.