There is a check valve on discharge line right next to water softener.
Water softener drain line check valve.
Check the brine line float for salt build up.
By code water softeners must be emptied into a laundry sink floor drain sump hole or properly trapped special outlet preserving an air gap of at.
There are a few reasons why your water softener keeps running over and over again.
I am concerned about there not being enough water pressure to open check valve.
The brine line valve can become clogged with debris from the water so look for salt clogging inside the tank as well.
Then there is 20 feet of 1 2 discharge line to p trap that is connected to existing 2 inch house sewer drain.
14 water softener keeps running.
Clogged valves or water lines.
This is to prevent non potable water from flowing backwards possibly mixing and contaminating potable drinking water.
In homes with high iron levels this is especially common and periodic cleaning is necessary to maintain water movement.
I installed the check valve to prevent sewage back up.
Check the caps of the brine tank and brine well for a tight fit.
If there is a blockage then you have to remove it.
Many water softener models use a check valve at the top or at the bottom of a brine pick up tube in the brine tank.
Click to enlarge any image.
Blocked drain hose water softener is not draining.
Check the water softener backwash regeneration drain tubing for clogs bends crimps or routing too high above the unit.
A check valve minimizes water pressure and pressure decreases and allows for continuous smooth water flow.
The most common reason might be the impossibility to draw brine from the tank.
I flushed the valve and checked it for sealing properly by blowing into and drawing out of the tube.
Clogged or just partly clogged drain tubing or a too small drain line piping or a drain line not properly routed result in abnormal brine water levels.
Check the drain line for any kinks or clogs.
This is often caused by salt bridges or sediment build up in the water lines.
The drain line flow control valve can also develop a blockage.
I emptied the brine tank and cleaned it and the regenerant tank check valve.
If your brine line float control gets clogged with salt take it out wash it and check to make sure it s working correctly clogging can occur where the brine.
A backflow preventer keeps water flowing in one direction to stop the reverse flow of contaminated water to your drinking water supply.
