Water Softener Regeneration Steps

Here are the typical water softener regeneration steps.

Water softener regeneration steps.

To regenerate a softener that has reached capacity you must conduct four steps. These devices work by either using a clock or by monitoring the amount of water used demand initiated regeneration softeners to tell the water softener when it is necessary to shut down and regenerate. The brine solution flows through the resin tank rinsing the beads and exchanging new sodium for the hard water minerals that have collected. The third and last step of the regeneration is to pass a high capacity flush of water through the mineral to ensure salt free water goes to the tap.

A strong salt water brine solution is created with the salt added to the softener. The softener then goes back into what we call service position and the owner enjoys another 1 200 gallons plus or minus of soft water. To improve efficiency and extend the life of your water systems scale causing calcium and magnesium ions are replaced with sodium ions in the softening process. Remove the lid and refill your water softener s salt hopper with softener salt then close.

Backwash 10 minutes this step removed accumulated dirt and such while also fluffing up the media bed. The regeneration process starts with a backwash during which the softener pumps water backward through the treatment medium to remove sediment. The majority of home water softeners are equipped with automatic regeneration devices. The following steps are involved with regeneration.

Water softeners regenerate by removing trapped contaminants and replacing them with either sodium or potassium depending on which chemical you put in the brine tank. This step takes about 10 minutes. Backwash brine draw slow rinse and fast rinse.