This usually happens due to a lack of overflow or clogging.
Water softener salt tank full of water.
For optimum water softener performance you should be sure to keep your salt level above the water level which is usually about one quarter full but do not overfill it.
If it is set too high excess water may build up and your unit may not be able to release all the water after each discharge cycle.
You should never fill your tank more than about a six inch from the top this can encourage salt bridging and does not benefit the system in any way.
If your softener isn t fully draining during the regeneration cycle then your brine tank will eventually fill up with water until the safety float is engaged.
Hi can you tell me how much water should be in a brine tank of a water rite softener under normal use now it is full of water all the time is this normal.
If your water softener is full of water another potential solution is to change the kenmore water softener float setting.
Salt tank is full of water if there is a problem in the valve.
The more regularly your system regenerates the more often you will need to check and add salt to the brine tank.
1 water softener problems water in salt tank.
You can easily troubleshoot this by setting it on a lower grade.
Water rite 740 water softener has brine tank full of water what s the normal liquid level in the brine tank.
If this is your problem it s time to clean the tank.
Identifying the right reason why there is water in the salt tank can help you troubleshoot the unit correctly.
It is recommended that you check on the salt levels in the brine tank at least every 3 to 4 weeks.
I think this will just melt all the salt in the tank all the time.
If this valve is set high more than enough water will cause the salt tank issues.
Problems of salt bridges.
There will normally be a few gallons of water in the brine tank but this should never be more than 12 inches deep.
However the issue can be caused by multiple factors.
The salt water solution in your brine tank will become too diluted and your softener will not be able to regenerate properly.
Salt clog in the bottom of the tank.
There are horizontal slots in the brine well that allow water to flow in and out.
Perhaps the primary concern water softener users are facing is a salt tank full of water.
The valve controls the water entry so just replace it to resolve this if the problem is with the float valve.
If the salt buildup is clogging the tank at the bottom that will reduce the amount of water that can enter the tank absorb salt and then flow back out.
