Water Softener Valve Position

There are usually three valves.

Water softener valve position.

The bypass valves are located where the water softener connects to the water pipes. If the position switch breaks the motor runs constantly. Normally the valves are in a horizontal position when the. Water softener bypass valve operation repair guide.

The rotor position switch tells the timer what position the rotor is in so the timer knows when to start the motor that turns the valve rotor through cycles. Check the valves positions. Also open the valves to the water heater and restore its power and or turn the gas valve back on and relight the pilot if necessary see how to relight a gas water heater. This diy repair guide explains how to replace the rotor position switch in a water softener.

To put in a water softener open the water supply valve to the 1 4 position to let oxygen run from the drain line. We explain what is the bypass valve on a water softener where to find it and we describe when how to position the valve to take the water softener conditioner in or out of service. Find the valves by following the 2 large hoses running out of the water softener. This is usually behind the water softener s control box.

These are the inlet and outlet hoses for water moving through the softener. Put your conditioner into the backwash stage and set the bypass valve to the service position. Follow them to lead you to the bypass valve. Locate the water softener then look for 2 large hoses running out of it normally either out of the side or the back.

Turn the water supply valve completely on when a steady stream of water appears at the drain.