Water Sprinkler Valve Leaking

Sprinkler valve leaks are important to address because even the smallest leak will waste more water and more money every day that the leak goes unattended.

Water sprinkler valve leaking.

The second reason that a sprinkler system could leak when off is that the valve for the whole zone is leaking and allowing new water into the system. The backflow valve is normally located between the water supply connection and the sprinkler system in your home. Hunter sprinklers are also able to have check valves added in the field after they are installed. The lowest sprinkler on one of the lines is leaking water all the time.

Unscrew the bonnet from the top of the valve using a phillips screwdriver. Pack valve box with dry rags to absorb water. Everything has been good for years and years now things are not working like they should. Shut off the water to the sprinkler system.

Remove the old washer and slide on the new one. Remove lid from valve box and clean out mud from inside of box with hand trowel. 0 09 check your water meter it is usually out by the street. Reinstall the packing nut tighten lightly with a wrench don t over tighten at this or any other point and reattach the handle.

Twist out the low voltage solenoid valve then wait for excess water to drain out. The other reason may be water leaking through the zone valve a check valve in the sprinkler will not fix this leak. This will also ensure that your drinking or potable water supply shouldn t be contaminated with chemicals or debris from the garden. One other valve is leaking at the anti siphon valve when the.

When there doesn t seem to be any visible damage to the sprinkler head then damage to the valve seal is likely the culprit. This is intended to prevent any flow of water from going backward. This type of leak creates a steady small trickle that does not stop. So your sprinkler system is off but your sprinklers are still leaking water.

The most common reason why water leaks through a valve is because there is debris obstructing the valves diaphragm. Next remove the handle from the stem and then loosen and remove the packing nut. The two most likely culprits are a leaking valve or low head drainage. The leak may be at one or more of the sprinkler heads in the zone.

Turn the water back on open the. First shut off the water to the leaking water valve. This creates a more positive seal as the male thread is twisted into the female thread to prevent leaks.